哪位仁兄有P5控制面板按钮的使用相关代码的手册？

哪位仁兄有P5控制面板按钮的使用及相关代码的手册？谢谢了。

这个我也想要
有的分享一下吧

给个链接也好了

精华贴里有

给个关键字吧

P5面板参数含义


OS IPL types
A IPL from disk using copy A of the system Licensed Internal Code.
B IPL from disk using copy B of the system Licensed Internal Code.
C Reserved for hardware service use only under the direction of Rochester development support. Attention: Severe data loss can occur with improper use of this function.
D IPL from media other than load-source disk. Alternate IPL for code installation support.

System operating mode values
Manual (M) Allows you to access DST and perform an attended IPL.
Normal (N) Allows you to access the operating system and perform an unattended IPL.

IPL speeds
F Fast override for one IPL. Fast IPL run. Some hardware diagnostics are skipped.
S Slow override for one IPL. Full hardware diagnostics run. Use whenever hardware is changed, for intermittent hardware failure, and on the first installation IPL. The following diagnostics are run: v Main storage tests. v CEC Inter-chip interface tests (wire test). v Extended Logical Built-in Self Tests.
V=F Use system-defined speed. Fast IPL set by system value (displayed at function 01).
V=S Use system-defined speed. Slow IPL set by system value (displayed at function 01).
V Fast IPL or slow IPL set by the system value (selected at function 02). Function 02 selection or the system default at each IPL.

Firmware IPL types
P IPL from disk using copy P of the system Licensed Internal Code.
T IPL from disk using copy T of the system Licensed Internal Code.

HMC indicators
HMC=1 The HMC is connected.
HMC=0 The HMC is disconnected.

IPL initial program load, 就是自举，boot

为保证可靠，里面有两套微码，a，b，这样升级一套，如果不行，可以退回来。
LIC就是微码。
A IPL from disk using copy A of the system Licensed Internal Code.
B IPL from disk using copy B of the system Licensed Internal Code.

Rochester，罗切斯特，建议看看银湖计划和罗切斯特城堡两本书，就是as400的研发地，现在6000和400硬件合并，由于400做得可靠性高，架构好，所以很多底层的东西都沿用了400的东西，这个C选项就是只有18m内部开发的人使用的，你最好别动，否则：后果自负！哈哈
C Reserved for hardware service use only under the direction of Rochester development support. Attention: Severe data loss can occur with improper use of this function.

除了a，b code，如果都坏了？让你从别的地方启动微码，或者安装微码，例如光盘，当然也是“专业”服务的人动的，你没事别研究，研究出事情概不负责。
D IPL from media other than load-source disk. Alternate IPL for code installation support.

System operating mode values
Manual (M) Allows you to access DST and perform an attended IPL.
Normal (N) Allows you to access the operating system and perform an unattended IPL.

DST：debug system tool，就是进入硬件微码调试


IPL speeds
F Fast override for one IPL. Fast IPL run. Some hardware diagnostics are skipped.
S Slow override for one IPL. Full hardware diagnostics run. Use whenever hardware is changed, for intermittent hardware failure, and on the first installation IPL. The following diagnostics are run: v Main storage tests. v CEC Inter-chip interface tests (wire test). v Extended Logical Built-in Self Tests.

CEC不用说了吧？就是处理器抽屉

V=F Use system-defined speed. Fast IPL set by system value (displayed at function 01).
V=S Use system-defined speed. Slow IPL set by system value (displayed at function 01).
V Fast IPL or slow IPL set by the system value (selected at function 02). Function 02 selection or the system default at each IPL.

Firmware IPL types
P IPL from disk using copy P of the system Licensed Internal Code.
T IPL from disk using copy T of the system Licensed Internal Code.

HMC indicators
HMC=1 The HMC is connected.
HMC=0 The HMC is disconnected.






垃圾猪
Orian
Enjoy the fun of life...
email & msn: [email]ensighine@yahoo.com[/email]

sorry，这是我在网上找到的，转给大家

谢谢分享

再问一下,P5小机液晶面板旁的那个RJ45电口是做什么用的?

那个是当串口用吧

我试着插网线,都不通.

面板上的口,和机器后面的串口1,是一个口

LS正确。那是RJ48的口

我这有个，你看能用不？

我手头上有个前几天刚下载的，你看下对你是否有帮助！

回复 #1 luckyma 的帖子

楼主你好！！现在手头上有使用相关代码的手册了吗！！方便放到论坛上，大家一起分享！！谢谢！

是啊 很需要 哪位大虾有

上面不都列出来了么？