SVC Node Replacement and Node Addition Procedures
Document Author:
William F Wiegand
Document ID:
TD104437
Doc. Organization:
Advanced Technical Support
Document Revised:
2008-02-05
Product(s) covered:
# 2145
Abstract: The scope of this document is two fold. The first section provides a procedure for replacing existing nodes in an SVC cluster non-disruptively. For example, the current cluster consists of two 2145-4F2 nodes and the desire is to replace them with two 2145-8x4 nodes maintaining the cluster size at two nodes. The second section provides a procedure to add nodes to an existing cluster to expand the cluster to support additional workload. For example, the current cluster consists of two 2145-8F2 nodes and the desire is to grow it to a four node cluster by adding two 2145-8G4 nodes.
The objective of this document is to provide greater detail on the steps required to perform the above procedures then is currently available in the SVC Software Installation and Configuration Guide, SC23-6628, located at
www.ibm.com/storage/support/2145. In addition, it provides important information to assist the person performing the procedures to avoid problems while following the various steps.
[
本帖最后由 小猪 于 2008-4-21 14:29 编辑 ]