原帖由
炸鸡 于 2008-4-30 16:19 发表
沒辙了，我的层面已经不能再做下去了。
emcer直接在sym里reset了这个reservation，我这边马上就认出pvid。
他们没告诉我方法，但肯定的是我做不了的。连ECC也做不了。
原因可能是上次的主机用的时侯 ...
看了下命令速查手册，symdev -sid symmid -noreserved就应该可以了
symdev [-sid SymmID] [-offline] [-v] [-resv] [-wwn] [-all]
list [-SA <#|ALL>][-P #][-scsi][-fibre]
[-RANGE SymDevStart:SymDevEnd] [-R1] [-R2] [-cyl]
[-CAP #][-N #][-vcm][-held] [-gige] [-ficon] [-escon]
[-noport|-firstport|-multiport] [-bcv|-nobcv|-drv]
[-meta] [-hotspare] [-dynamic] [-worm] [-vdev]
[-savedev] [-raids] [-rdfa] [-disk_group nn]
[-raid5 [-protection 3+1 | 7+1]]
[-raid6 [-protection 6+2 | 14+2]]
[-emulation fba | ckd | as400 | celerra] [-star_mode]
[-star_sync_target] [-star_async_target]
[-half_pair] [-dup_pair] [-bcv_emulation]
[-reserved | -noreserved]
[-service_state [not]degraded | [not]failed |
[not]normal]
list pd [-SA <#|ALL>][-P #][-scsi][-fibre]
[-RANGE SymDevStart:SymDevEnd] [-R1] [-R2] [-cyl]
[-CAP #][-N #][-vcm][-held] [-gige] [-ficon] [-escon]
[-noport|-firstport|-multiport] [-bcv|-nobcv|-drv]
[-meta] [-hotspare] [-dynamic] [-worm] [-vdev]
[-savedev] [-raids] [-rdfa] [-disk_group nn] [-raid5]
[-raid5 [-protection 3+1 | 7+1]]
[-raid6 [-protection 6+2 | 14+2]]
[-emulation fba | ckd | as400 | celerra] [-star_mode]
[-star_sync_target] [-star_async_target]
[-half_pair] [-dup_pair] [-bcv_emulation]
[-reserved | -noreserved]
[-service_state [not]degraded | [not]failed |
[not]normal]
symdev [-sid SymmID] [-offline]
list [-DA <#|ALL>] [-interface <#|ALL>]
[-disk <#|ALL>][-hyper <#|ALL>] [-firstport]
symdev [-sid SymmID] [-offline]
list -space [-cyl] -DA <#|ALL>
symdev [-sid SymmID] [-v]
list -lock [-RANGE SymDevStart:SymDevEnd]
symdev [-sid SymmID] [-offline]
list -inventory
symdev [-cid ClarID] [-offline]
list -clariion [-CAP #] [-N #]
[-RANGE SymDevStart:SymDevEnd]
symdev [-sid SymmID] [-offline] [-cyl]
show SymDevName
symdev [-sid SymmID] [-force]
release [-lock #] [-RANGE SymDevStart:SymDevEnd]
[-noprompt]
symdev -sid SymmID [-noprompt] [-celerra] [-star]
rw_enable SymDevName [-SA <#|ALL> [-P #]]
write_disable SymDevName [-SA <#|ALL> [-P #]]
ready SymDevName
not_ready SymDevName
relabel SymDevName
hold SymDevName
unhold SymDevName [-symforce]
symdev -sid SymmID -file FileName [-noprompt][-celerra]
[-star]
rw_enable [-SA <#|ALL> [-P #]]
write_disable [-SA <#|ALL> [-P #]]
ready
not_ready
relabel
hold
unhold [-symforce]
[
本帖最后由 笑看风云淡 于 2008-5-6 09:20 编辑 ]
